Page 11
3.1.2 – Seat width
Adjustment in width from 40 to 50 cm modulo 2cm.
Put the chair in a verticalized position
Perform the adjustment in two steps, one on each side
of the chair.
•
Using a 4 mm hexagonal 6-sided wrench, remove
the four seat width adjustment screws (on one
side) (see figure 13)
Figure 13 : Seat width adjustment
•
Using a 5 mm hexagonal 6-sided wrench, loosen
the four armrest width adjustment screws on the
same side as before. (See figure 14)
Figure 14 : adjustment width backrest & armrests
•
Adjust to the desired seat width
(using the graduation at the front edge of the seat
see figure 15)
Replace the 2 seat width adjustment screws and the
four armrest width adjustment screws
Repeat the operation on the other side and control the
width using the tick mark
Figure 15 : read seat width
