PowerTec UT1004, Owner'S Manual

2

ASSEMBLY

ASSEMBLY

2

UNPACKING

Refer to Figure 1

Check for shipping damage. Check immediately whether 
all parts and accessories are included. 

ITEM DESCRIPTION

QTY

A 

Ultra-work stand

1

B 

Extension bars

2

C

Roller bars

2

D

Locking knobs

4

E

Handle

1

F

Screws and lock nuts (handle)

2

G

Power tool mounting hardware  
(mounting bolt, washer, lock washers and 
nut)

4

H

Pan head screws

2

B

A

F

C

D

E

G

Figure 1

H

     WARNING

Do not use the ultra-work stand until it is completely 
assembled and you have read and understood this entire 
operating manual and the operating manual of the tool 
being used with this ultra-work stand.

     WARNING

Do not use the ultra-work stand for scaffolding or as a 
ladder. Make sure to securely tighten all fasteners before 
using. Maximum capacity is 330 lbs. (150 kg). Power tools 
on the ultra-work stand should not exceed a combined 
overall height of 60" (152.4 cm) from the floor.

TOOLS NEEDED

The following tools (not included) are needed to assemble 
the ultra-work stand:
Phillips head screwdriver
10 mm open end wrench

UNFOLD THE WORK LEGS

Refer to Figure 2

•  Place the ultra-work stand on a flat surface with the 

folded legs facing up.

•  Depress the leg release spring pins and rotate the leg 

until it clicks and locks into the open position. Repeat for 
each leg.

Figure 2

Leg

Leg Release 

Spring Pins

•  Place the ultra-work stand in the upright position on a 

flat surface.  

ASSEMBLE HANDLE

Refer to Figure 3

•  Secure handle to frame with hardware supplied. 

Figure 3

Lock Nut Handle

Screw