13
INSTRUCTIONS PL600/PL1000
R
E
E
3). Wiring connection:
TX: Connect the (1) and (2) terminals on the transmitter with the ter12V and GND on the PL600/ 1000 PCB.
RX: Connect the (1), (2) and (4) NC terminals on the receiver with the te12V
、
GND and PH1 on the
PCB600/1000 PCB. And use an extra wire to connect terminal (2) and (5) on the receiver as bridge.
See
Figure 3.3.2 (4) Figure 3.3.2 (5)
.
Figure 3.3.2 (4)
Figure 3.3.2 (5)
Transmitter
Receiver
CA
CC
O
V
V
R
R
NA NC C
I
T
T
1
2
3
4
5
Z
NA: Normal Open
NC: Normal Close
: DC(+) Input Voltage
: DC(-) Input Voltage
C: Common CA:
AC(12~24) CC:
DC(12~24)
VERT:Vertical
ORIZ:Horizontal
CA
CC
O
NA NC C
R
1 2 3 4 5
I
Z
CA
CC
O
NA NC C
R
1 2 3 4 5
I
Z
Power LED: Green
Vertical Adjustment
Horizontal Adjustment
LED:Red(Beam Alignment)
3.3.3 PF-1 Flashing Light
1). Decide the installation position of the flashing light. The flashing light has to be installed near the gate and easy
to be seen by users and passersby. The flashing light can be installed horizontally or vertically. See
Figure 3.3.3 (1)
.
2). Unscrew the four screws on the light base and separate the base with the bottom as shown in
Figure 3.3.3 (2)
.
3.) Connect the wires and penetrate the wires into the hole of the base. See
Figure 3.3.3 (3)
.
4.) Drill the holes in the wall and fix the bottom to the wall by three screws. See
Figure 3.3.3 (4)
.
Figure 3.3.3 (1)
Figure 3.3.3 (2)
Figure 3.3.3 (3)
Figure 3.3.3 (4)
