Your battery charger features a clean geometric design executed with a heavy duty
extruded aluminum housing allowing for increased power and performance.
Incorporation of microprocessor and software control adds the latest pulse charging
technology resulting in cooler operation and faster charge times. Your charger is
fully automatic with a multi-stage digital performance charging profile that includes
5 sequential stages: Initializing, Fast Charging , Optimizing, Maintaining , Smart
storage; that is safe for short and long term storage. This process will not only
enhance the performance of all 12 volts flooded and AGM lead acid batteries, it will
also extend the lifetime of the batteries.
For the ease of use, the battery charger features a brand new intuitive user
interface display with individual LED indicators for each charging mode, AC
power-on diagnostics with a system check OK status indicator providing positive
confirmation that the charger connections are healthy and that the batteries can be
charged. The Digital Charge Monitor gauge indicates charging status progress
during the operation with a single red LED, indicating low battery(s) are being
charged. Dedicated battery fault indicators eliminate time consuming
troubleshooting and clearly indicate individual battery wiring faults or if a battery is
less than 2.5 VDC and cannot accept a charge.
Our chargers automatically senses and distributes 100% of available charging
amps to any or all of the banks as needed..
Energy Saving Mode: after fully charging and conditioning batteries, your charger
will monitor and maintain batteries automatically only when needed to keep their
full state of charge. This significantly reduces AC power consumption and lowers
operating costs while maximizing battery performance.
The Battery Charger is compact, lightweight and prewired for each installation. The
charger is 100% waterproof. Built with peace of mind safety every unit incorporates
In-line DC fuses for all battery banks, over-voltage, overload, over-temperature,
reverse polarity and ignition protection.
8
15
General Overview
Installation
When connecting each jacketed battery charger cable, make sure it is connected
to only
one 12 VDC
battery
and observe the polarity and color of all connections:
• Red Wire to the “+” (Positive) Battery connection
• Black Wire to the “-” (Negative) Battery connection
The black wire can never be connected to a terminal with red wires and vice
versa.
Important: The pair of red and black wires in 1 cable jacket MUST GO TO
THE SAME 12VDC battery.
24 VDC
Trolling Motor or House Battery Configuration with (2)
12 VDC
Batteries
Connected with a Series Jumper Plus Dedicated
12 VDC
Engine Start Battery
Fig. 2 Three Bank Charger for three 12V Batteries
3 Bank Charger
Typical Wiring
