PowerTech PW320, User Manual

INSTRUCTIONS PW320/PW330

10

Figure 25

Figure 25.1

Figure 25.2

Figure 26

Figure 27

Figure 28

Figure 29

Figure 30

Figure 31

14. Fasten the nut tightly and loosen it for half round for motor supporting in rotating.
15. Fasten the motor front end to the front plate with the bolt (A) and nut (B) tightly. Fully tighten the screw.

12. Lift up the motor and insert the screws into the front plate.
13. Open the gear motor cover and release the screw, then take out the bolt as below 

Figure25

. Lift the motor   

      overhead and push the gate to the end until the screw holes of the motor end matches the holes on the rear plate 
      as shown in 

Figure 25.1

 and fasten the motor to the rear plate with bolt and screw as shown in 

Figure25.2. 

21. Connect the motor power cable as shown in 

Figure27

.

22. Close the gear motor cover by tightening the two screws as shown in 

Figure28

.

23. Gear Motor Release
    1) Turn the round plate on the release part to “OPEN” position. See 

Figure 29

.

    2) Push out the release part to the end. See 

Figure 30

.

    3) Use the release key to turn the pin anti-clockwise to the end. See 

Figure 31

.

1

1

2

2

3

3

PW320

PW330

White(+)

Yellow(-)

Motor

B

B

A