SAFETY POWERTEK
GENERAL SAFETY INFORMATION (CONTINUED)
2. PREPARATION
A. Be thoroughly familiar with all controls and with the proper use of the log splitter.
B. Always wear safety shoes or heavy boots. (No sneakers).
C.
Always wear safety glasses or goggles with side shields and hearing protection
when operating the log splitter.
D.
Wear safety gloves.
E.
Never wear jewelry, loose clothing or clothing with strings that might become entangled in
moving or rotating parts of the log splitter.
F.
Make sure the log splitter is on a level surface. Block the wheels securely before operating
the machine to prevent unintended movement. Use chocks or split wood in front and
behind each wheel to block the log splitter.
G.
Always operate the log splitter from the indicated operator zone. (See diagram page 10).
H.
Logs to be split should be cut as
squarely as possible.
I.
Handle fuel with care; it is highly flammable.
1. Use an approved fuel container.
2. Never add fuel to a running or hot engine.
3. Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors.
4. Replace gasoline cap securely and
clean up spilled fuel.
3. SAFE TRANSPORATION OF LOG SPLITTER
When transporting the log splitter over the road, fuel coming from the gas tank should be shut off
(if possible) by means of the shut-off valve located under the gas tank. Some engines do not have
a gas shut off.
4. OPERATION
A. Before starting this log splitter, read and understand this entire manual including the
Do Be
Careful and General Safety Instructions. Failure to follow these rules may result in serious
injury to the operator or bystanders.
B. Never leave the machine unattended with the power source operating.
C. Never operate the machine when under the influence of alcohol, drugs or medication.
D. The machine owner should instruct all operators in safe log splitter operation.
E. Always operate the log splitter with all safety equipment in place and all controls properly
adjusted for safe operation.
F. Do not tamper with parts that may increase the speed recommended by the manufacturer.
G. Always keep hands and feet clear of moving parts.
H. Always shut off the power source while repairing or adjusting the splitter except
as
recommended by the manufacturer.
9
