M520086-01
2-1
Chapter 2
INSTALLATION
2.1
INSPECTION
Inspect the shipping carton for possible damage before unpacking the unit. Carefully unpack
the equipment. Save all packing materials until inspection is complete. Verify that all items
listed on the packing slips have been received. Visually inspect all exterior surfaces for broken
knobs, connectors or meters. Inspect for dented or damaged exterior surfaces. External
damage may be an indication of internal damage. If any damage is evident, immediately
contact the carrier that delivered the unit and submit a damage report. Failure to do so could
invalidate future claims.
2.2 INPUT/OUTPUT CONNECTORS
Table 2-1 lists all external connections for the 3300 Series models.
For permanently connected equipment, a readily accessible disconnect device shall be incorporated in
the fixed wiring. For pluggable equipment, the socket outlet shall be installed near the equipment and
shall be easily accessible.
2.3 LOCATION AND MOUNTING
The 3300 Series models are intended for mounting in a standard 19.0-inch equipment rack.
Four captive screws, two on each side of the front panel, are used to secure the unit in place.
Optional slide mounting is available.
NOTICE
The unit should be provided with
proper ventilation. The top, rear and
both sides of the unit should be free
of obstructions.
Follow the instructions in paragraph 3.1.1 for setup and operation of the equipment.
