Powertow 35/40/KeyEZ/Thundervolt
Powertow 35/40/KeyEZ/Thundervolt
Page 6
ELECTRICAL CONNECTION - Place black battery cable lug onto negative (-) battery
terminal and tighten bolt to secure. Place red battery cable lug onto positive (+) battery
terminal and tighten bolt to secure. Route yellow/green wire pair with switch attached
along Powertow handle and mount switch in hole provided in upper handle. Connect
spade end of wires to spade located on switch. Secure yellow/green wires to handle
shaft with nylon tie wraps provided. Keep wire ties clear of moving parts. Securely
tighten all battery connections. Charge battery overnight, before first use. Automatic
Charger should be left plugged in when not in use.
Powertow (12 Volt Thundervolt)
F
Fo
orr F
Fu
uttu
urre
e R
Re
effe
erre
en
nc
ce
e
a
an
nd
d A
Ad
djju
us
sttm
me
en
ntts
s
Figure A - From Rear Motor View
Figure B - From Front Tire View
Step 1 Before placing battery in the tray connect spring to the battery tray see figure B
Step 2 Place Battery in the tray. Position hold-down clamp as shown in figure A
Step 3 Attach spring to hole in top of hold-down clamp by pulling up spring
with pliers.
ThunderVolt Battery Hold-Down Clamp Instructions
Refer to Diagrams 5 & 6 and instructions on facing page
