Service Manual
Chapter 4 - Operation and control
Operator Control Panel
4 - 6
3x3 UPS Operation and control
Issue 2 - November 2001
OPERATING LANGUAGE MENU
Up to five language are available in this menu. To select one language first move into the OPERATING LANGUAGE
display press ENTER and scroll the different languages up the desired one using NEXT button, than press ENTER
to confirm.
CLOCK MENU
This menu allows User to change the Date and Time setting on Hinet. To select Date or Time press first ENTER from
CLOCK menu then NEXT. When the Date or TIME are displayed the cursor will be over the last right character. To
scroll consecutive numbers use BACK and NEXT buttons, to move on the left use MENU button. Then type the whole
Date and press ENTER to confirm. If something is wrong in the Date or Time the message ERROR will be displayed
and the setting restart.
UPS CONFIGURATION MENU
It is strongly recommended that only trained people can have access to this menu.
In this menu the following parameters can be adjusted:
D
Serial Number of the Unit
D
Telephone number of Service Dept.
D
Battery Capacity (Battery Ah at the C10 rate)
D
Calibration'. Display calibration of the following parameters:
1. Input Current and Voltage. Calibration of measured Values
2. Output Current and Voltage. Calibration of measured Values
3. Battery Current and Voltage. Calibration of measured Values
To enter in one of these menu follow the procedure below:
a) Press the `MENU' push button (A) on the FRONT PANEL.
b) Select the `UPS Configuration' screen by pressing either the `BACK' ( C ) or `NEXT' ( B ) push button.
c) Confirm the `UPS Configuration' menu selection by pressing the `BACK' and `NEXT' push-buttons at the
same time (i.e. ENTER).
d) Select one of the following parameters (Serial Number, Service Phone Number, Battery capacity, Calibration)
by pressing either `BACK' ( C ) or `NEXT' ( B ) push button.
e) Confirm the selection by pressing and hold for at least 20 seconds `BACK' and `NEXT' push button at the
same time.
f) Select the correct value by pressing either `BACK' ( C ) or `NEXT' ( B ) push button.
g) Confirm the correct value by pressing `MENU' push button.
h) Press the `CLEAR' key to return to the main menu.
Note: These parameters are factory set and it is not recommanded to adjust them during
commissioning.