R&D – TECHNICAL SPECIFICATION DT0424-E01
Powertronix spa reserves the right to modify this document without notice
Page
.
32 of 73
4 PC BASED CHECKS AND SETTINGS
As the UPS is equipped with LCD panel, most of basic operations can be done by the
user without using additional tools. Although, for the convenience and time save while
executing more complicated operations, the UPS logic control can be accessed also by
PC with dedicated POWERTRONIX UPS Maintenance
UCT
program.
This program is also the only way to modify some UPS parameters which are not
accessible through LCD panel.
Necessary things: PC with program installed, serial communication cable DB9-DB9 and
RS232 / Relay board CS0098 (standard on-board)
.
Below there is a short description of the program and its possibilities.
Few seconds after start, the program will be ready to use. The initial screen is similar to
the following picture:
As there is no standard way of using the program, the informations below contain just the
description of major functions. The user decides, which of them wants to use.
In most of cases it will be necessary to start the transmission between UPS and
computer. To do this, the user must define the serial port number and transmission
speed (usually 2400 bps),