User manual 6/10 kVA Rev.2
POWERTRONIX . - Page 25 of Total 29 - January 2006
5. Troubleshooting
LED Status /
Audible Alarms
Possible Cause
Action
Battery not yet
been fully charged.
Keep UPS connected to utility power
continously for more than 10 hours to
recharge the batteries again.
UPS overloaded.
Check the loads and remove the non-critical
equipment.
Battery discharging
time diminishes
Battery aged.
Replace the batteries. Please contact the
distributor to obtain the parts and
replacement service.
The “ON” button is
pressed too briefly. Press the “ON” button for more than 1 second.
The UPS is not
connected to the
battery or the
battery pack
voltage is too low.
Check the battery or recharge the battery.
The UPS cannot
power on after
pressing the ON
button
UPS fault.
Please contact the Sales Representatives.