ENGLISH
disable or enable the alarm system. But it’s not applied to the situations when warnings
or errors occur.
Press this button to display previous selection in UPS setting mode (up key)
Press and hold ON/Mute button for 5 seconds to enter UPS self-testing while in AC
mode, ECO mode, or converter mode.
OFF/Enter Button
Press and hold this button at least 2 seconds to turn off the UPS. UPS will be in standby
mode under power normal or transfer to Bypass mode if the Bypass enable setting by
pressing this button.
Press this button to confirm selection in UPS setting mode.
Select Button
Press this button to change the LCD message for input voltage, input frequency, battery
voltage, output voltage and output frequency. It will return back to default display when
pausing for 10 seconds.
Press and hold this button for 5 seconds to enter UPS setting mode when UPS is in
standby mode or bypass mode.
Press this button to display next selection in UPS setting mode. (down key)
ON/Mute + Select Button
When the main power is normal, press ON/Mute and Select buttons simultaneously for 5
seconds. Then UPS will enter to bypass mode. This action will be ineffective when the
input voltage is out of acceptable range.
VII.
UPS Setting
Parameter 1
Parameter 2
Parameter 3
01
Output voltage
setting
200/208/220
/230/240
Value in V AC
02
Frequency
Converter Mode
CF
Converter Mode
ENA/dIS
Enable or Disable (default)
03
Output
frequency
setting
CF
Converter Mode setting (if
enabled)
50 / 60
Value in Hz
BAT
Battery Mode setting
50 / 60
Value in Hz
04
ECO Mode
ENA/dIS
Enable or Disable (default)
05
ECO
voltage
range setting
HLS
Upper Limit for Input Voltage
Nominal
+7V to +24V
Value in V AC
LLS
Bottom Limit for Input
Voltage
Nominal
-7V to -24V
Value in V AC
06
Bypass
ENA/diS
Enable or Disable (default) bypass
mode
07
Bypass
Input
Voltage setting
HLS
Upper Limit for Input Voltage
230-264
Value in V AC
LLS
Bottom Limit for Input
Voltage
170-220
Value in V AC
08
Autonomy
Limitation
setting
0-999
Backup time limit in minutes. 0
actually means 10s and 999
means disabled
00
Exit setting
