Stand-Alone
2 Battery Cabinets
beginning the following procedures, be sure you have prepared the UPS for
installation of stand-alone
cabinets
page 17). Refer to figure 22 on
page 36 and Drawing 164200253-7 on page A-16 for the location of items
mentioned in these
prepare
2
cabinets for
stand-alone
1.
Unlock the
side door of the battery
using the key provided. Open
the door (press the top of the door latch, twist the latch lever clockwise
and
pull the door outward).
2. Remove the screws securing the right side door and open the door. Save
for later reuse.
WARNING:
LETHAL VOLTAGE WILL BE PRESENT WHEN
PERFORMING
THE
REMAINING STEPS IN THIS
AND SUBSEQUENT SECTIONS.
center
Retain and its
for later reuse.
4. you
installing more than one battery cabinet, perform steps 1 through 3 for
each cabinet.
To
stand-alone
2 battery cabinets
together:
cabinets will
at your
battery
disconnected.
the screws that Secure the left cable
connector, and remove the
See Figure 22 on page
connector
locations.
2. In the adjoining cabinet to the left, remove the screws securing
right
3.
the
cable connector to the right cable connector in the adjoining
cabinet to the left
Figure 22 on page
to locate the cutout for routing of
and
4. Repeat steps 1 through 3 of this procedure for each battery cabinet to be
Plus
UPS Installation
Summary of Contents for Plus 80
