I
I
I
I
I
I
I
I
I
I
I
Before installing an
be sure you have prepared the UPS according to the
instructions on page 19. You can install up to two
or up to
or one
of each.
To
install
an RMP:
Securely mount the
2. Install wiring from the RMP through
and through the
knockout
in either the top or bottom of the UPS cabinet.
The top entry connection requires installation of
flexible conduit
the
UPS. Bottom entry connection requires no additional routing of conduit within
the UPS.
3. In the hardware
locate the terminal block bracket (see Figure 39).
Connect to
Connect to
Port 1
Port 1
on Customer
on Customer
Interface Panel
Interface Panel
TERMINAL
TERMINAL
BLOCK
BLOCK
Plug the connector on the back of the terminal block into the DE-9 connector
on the Communications Panel of the UPS (see Figure 31). Use two screws from
the hardware
to secure the terminal block bracket to the Communications
Panel.
UPS
Manual
Summary of Contents for Plus 80
