24'
C
LASS
R
OPE
A
NCHOR
W
INCH
P
OWERWINCH
4
1. If not previously done, remove the 4 screws and cover and set aside.
2. Place the mounting template on the deck in the desired
location and secure
with tape.
2.1. The winch may be mounted on the fore (front) or aft (rear) of the boat.
2.2. When mounted, the roller assembly must extend past the deck to allow
anchor to clear the deck when retrieving or when the anchor is docked
in the roller.
3. Drill the holes as marked on the template.
4. Remove the template.
5. Assemble the safety chain.
5.1. Place one split ring at one end of the chain.
5.2. Attach the safety bar to the other end of the chain using a split ring.
NOTE:
It may be necessary to remove links after the anchor has been
attached and drawn up. The chain should be tight when attached to the
anchor.
6. Place a bead of silicone sealant around the base of the winch and the
around the newly drilled mounting holes.
7. Set the anchor on the deck and align the holes in the frame with the holes
drilled in the deck.
8. Secure the winch to the deck using four (4) each of 1/4 x 3" bolt, fender
washer, lock washer and nut. On the forward bolt, slide the bolt through the
open split ring of the safety chain then slide the bolt through the frame and
deck hole.
9. Attach the davit roller assembly to the frame as shown.
10. Attach the safety cover using two (2) #8 x 1/4" pan head screws.
