P
OWERWINCH
24'
C
LASS
R
OPE
A
NCHOR
W
INCH
7
O
PERATING THE
W
INCH
The anchor winch is simple to operate.
To Lower:
Press the switch in the down position to lower the anchor.
To Raise:
Press the switch in the up position.
NOTICE
Do not pull the boat to the anchor point with the anchor winch.
This can cause damage to the winch motor. Always use the boat motor to move
toward the anchor point.
S
AFETY
C
HAIN
The safety chain is designed to hold the anchor in place when the anchor winch
is not in use. The safety chain is used when the anchor is in the
UP
position.
WARNING
Always attach the
safety chain when the anchor is in the up
position. If the anchor should break loose when
the boat is cruising or being trailered, severe
damage and/or injury can occur.
To attach the safety chain, slide the safety bar
through the shackle.
Note:
The chain should fit tightly to securely hold
the anchor. Remove chain links as necessary.
M
AINTENANCE
Following each boat outing, flush exterior of winch with fresh water. Use only
mild detergents to clean exterior. Use of solvents can cause damage to the
finishes and seals, as well as void product warranty
.
Check electrical connections every 6 months for corrosion. Replace any
connection or wire which is damaged, corroded, frayed or worn.
Check rope periodically for abrasion or deep cuts. Never splice an old rope with
a new rope. If replacement is necessary, use only Powerwinch® rope
specifically designed for this product.
T
ROUBLESHOOTING
G
UIDE
W
INCH
D
OES
N
OT
O
PERATE
A. Confirm power to winch
Correct as required.
1. Check battery is fully charged
2. Confirm connections are tight & clean.
3. Check wires are worn or bare that may
cause shorts
B. Check circuit breaker at battery
Bypass circuit breaker and test winch.
Does the winch run?
NOTICE
Do not operate the winch
without the circuit breaker. Removing the
CB from the circuit is
ONLY
for testing.
Y
ES
If winch runs, circuit
breaker is bad, replace.
N
O
Reconnect circuit breaker
and go to step C.
C. Anchor is too heavy
Correct as required.
The maximum anchor weight for this winch is
40 lbs.
PW24006
Safety Bar
Chain
Shackle
