P
OWERWINCH
36',
41'
AND
46'
A
NCHOR
W
INCH
3
Required Materials for Electrical Installation – 46' Class
The following items are required
for the electrical installation of the 46' winch.
These items are furnished by the installer.
Qty
Description
8 ft 16 awg R
ED
Wire Class
105˚C 16 awg wire is used to connect the switch to
the relay module. Wire length is dependent
on installation.
8 ft 16 awg W
HITE
Wire Class 105˚C
8 ft 16 awg B
LACK
Wire Class 105˚C
70 ft 6 awg R
ED
Wire Class
105˚C 6 awg wire is the "run" wire from anchor to
relay module and battery to relay module.
Wire length is based on installation.
70 ft 6 awg B
LACK
Wire Class
105˚C
6
5/16" 6 awg ring terminals
4
3/8" 8-10 awg insulated female
spade quick disconnects
6
1/4" 16 awg insulated female
spade quick disconnects
1
In-Line Fuse Holder
1 10A
fuse
2
16 awg butt connectors
2
1/4-20 x 1/2 Screws
Screws and nuts should be stainless
steel to avoid rust and corrosion.
2 1/4-20
Nuts
Wire
ties
2 ft 1" diameter heat shrink
1 ft 2" diameter heat shrink
R
OPE AND
C
HAIN
R
ODES
This product is designed to raise and lower anchors using spliced rope and chain
rodes (a rode is a length of rope and chain).
It is very important that only sizes
and brands of spliced rope and chain rodes specified below are used. Use of
non-specified ropes and chains could cause reduced levels of performance or
serious personal injury and/or property damage.
Recommended Rope and Chain Rodes
M
ODEL
R
EQUIRED
R
OPE
R
EQUIRED
C
HAIN
36'
1/2" Diameter, 3 strand, medium lay, premium
nylon Powerwinch rope or New England Rope
1/4" Acco G4
Hi-Test chain.
41' and 46'
5/8" Diameter, 3 strand, medium lay, premium
nylon Powerwinch rope or New England Rope
5/16" Acco G4
Hi-Test chain.
NOTICE
Use only spliced rope and chain rodes. Shackles should never
be used to secure rope to chain. Shackles will damage winch and void warranty.
CAUTION
ALWAYS use the recommended rope and chain rode. Use
of different rope can cause property damage and personal injury.
Rope and chain rodes are sold separately and not included with winch.
R
OPE
L
OCKER
The anchor winch must be positioned
above a rope locker. The anchor line and
chain feed into the rope locker through a
deck insert (rode glide) mounted through
the deck. Minimum locker dimensions for
storage of lines are shown.
Line
Dimensions
Locker Dimensions
L x W x D
1/2" x 200'
15" x 17" x 12"
1/2" x 300'
15" x 24" x 12"
5/8" x 200'
15" x 24" x 12"
5/8" x 300'
16" x 32" x 12"
