P
OWERWINCH
36',
41'
AND
46'
A
NCHOR
W
INCH
5
1.
Place the mounting template on the deck in the desired
location and secure
with tape.
•
The winch must be placed above the rope locker.
•
The centerline of the gypsy must line up with the centerline of the davit
or bow roller.
2.
Drill the holes as marked on the template.
3.
Remove the template.
4.
Place a bead of silicone sealant around the base of the rode guide. Insert
the rode guide into the 2 1/2" hole.
The half-moon cut out must face the
davit or bow roller.
5.
Use a small amount of thread locker and thread the 5/16-18 x 3 1/2" studs
into the winch. Hand tighten until snug.
6.
Align the winch over the rode glide and align the studs with the holes in the
deck. Insert the wires through the hole in the deck.
Lower the winch to the
deck.
7.
Under the deck, secure the winch to the deck use one (1) each 5/16 flat
washer, 5/16 lock washer and 5/16 nut on each of the studs.
Tighten the
nuts to secure the winch to the deck.
W
IRING THE
U
NIT
WARNING
S
HOCK
H
AZARD
.
A
LWAYS
disconnect the battery before
working on electrical equipment.
WARNING
A
LWAYS
use the recommended wire size and rated circuit
breakers. Failure to use the furnished and recommended sizes can cause a fire
hazard and void warranty.
NOTICE
When routing the wiring, avoid sources of heat.
NOTICE
When routing the wiring, avoid sharp edges that can cut or fray
the wire insulation.
