Solution Tank:
The solution tank is located under the lid, at
the front of the machine, with the filling-funnel
M1
in an acces-
sible position for easy re-filling.
WARNING:
Always switch off and unplug the machine before
filling the solution tank.
Note:
Always empty the dirty water collection tank, as described
in the next paragraph, before refilling the tank with the diluted
detergent solution. The solution tank has a maximum capacity
of 5.75 gallons (22 liters). Always use the products and the
dilution quantities recommended by the seller. Always use low
foam detergents. Use defoamer if excess foam develops.
Remove hose from vac intake and pick up defoamer directly
into the recovery tank.
Water collection tank:
The dirty water collection tank should
be emptied, preferably each time after use, so that the dirt does
not settle there. To do this, remove the plug of the drain hose
M2,
which is kept in position by a simple spring clip, and
empty dirty water into the proper drain conforming to local reg-
ulations.
Squeegee:
The squeegee has the final task of completing the
drying of the floor and it is very important for it to be in the
correct position. Lower the squeegee to the working position
by depressing pedal
M3
as shown. Adjust the position of the
squeegee by means of the knobs
M4
so that the black rubber
bar is about
1⁄32" (the thickness of a business card)
from
the floor. The squeegee behind this is in para rubber and must
press on the floor with a certain amount of force.
After the
first few hours the squeegee adjusts itself to the cor-
rect angle and drying becomes even better.
Squeegee
pressure is adjusted by knob
M14
.
- 5 -
120 Volt
60 Hz
GENERAL OPERATION
