Powr-Flite PAS28032DX, Operator'S Manual

The operator must not wear clothing with wide sleeves, laces or belts; he 
must not approach the machine with bare or wet feet; he must not pull out 
the plug by pulling the cable; must not smoke if the environment or pro-
ducts used do not allow it. 

- For lifting and transporting use only specialized personnel (slingers,  
  crane operators, etc.) with proper lifting gear which is suitable for the  
  weight of the various components.

- Transport (especially by road) must be carried out with in the correct  
  way and with the adequate means so as to protect the components  
  (especially the electronic ones) from violent shocks, humidity, vibration,  
  etc; the machines are supplied with wheels and therefore need to be  
  securely anchored before beginning transportation.

- We remind you that packing material (wood, nails, paper, cellophane,  
  metal staples, adhesive tape, straps, ropes, etc.) may cause cuts or  
  wounds and should be handled with care. These must be removed with  
  appropriate tolls and should not be left in the care of irresponsible  
  people (e.g. Children); the same applies to the un-packing tools  
  (scissors, hammers, pliers, knives, etc.).

- On specific request, Powr-Flite will pack the machines appropriately  
  but this does not eliminate the above safety notes.

During movement, suspended loads made up of machine components or 
parts represent a collision, risk, it is the responsibility of the customer to 
highlight this danger.

WARNING:

 before attempting to adjust or prepare the machine or to fill 

the tanks, make sure that the power supply is disconnected.

Detergent tank:

 The detergent tank is positioned underneath the upper 

cover at the front of the machine with the filter hole M1 easily accessible 
for easy refilling. Before filling the tank with correctly diluted detergent, 
empty the waste collection tank as described in the following paragraph; 
obviously this step is not required for the first time of filling. The capacity 
of the detergent tank is 80lt. Only use the quantities and dilution recom-
mended by the detergent supplier and use only non-foaming detergents.

Waste tank:

 The waste tank should be emptied (preferably after each use) 

so as not to let the dirt settle; to do this, remove the cap covering the drain 
tube 

M2

 which is held in place by a retaining spring, and put in a position 

so that it drains. Always abide by the environmental regulations of the coun-
try where the machine is used.

Wiper blade: The floor wiper serves to finish the drying operation and it is 
very important to ensure it is in the correct position: lower the wiper to its 
working position using the foot pedal 

M3

; level the wiper using the knobs 

M4

 so that the black rubber strip is approximately 1/4” above the floor.

The remaining para rubber strips must wipe the floor with a certain 
amount of pressure; after the first few hours of operation the rubber wip-
ers adapt themselves to the inclinations and the drying action improves. 
Pressing the knob 

M14

 regulates the pressure of the wipers on the floor. 

When cleaning shiny or smooth floors and when there are holes (joins 
between tiles) it is advisable not to use the rear (lowest) rubber wiper.

- 4 -