background image

6

For lifting and transporting use only specialized personnel (slingers, crane operators, etc.) with 
proper lifting gear which is suitable for the weight of the various components.
Transport (especially by road) must be carried out in the correct way and with the adequate 
means so as to protect the components (especially the electronic ones) from violent shocks, 
humidity, vibration, etc.; the machines are supplied with wheels and therefore need to be securely 
anchored before beginning transportation.

We remind you that packing material (wood, nails, paper, cellophane, metal staples, adhesive 
tape, straps, ropes, etc.) may cause cuts or wounds and should be handled with care.  These 
must be removed with appropriate tools and should not be left in the care of irresponsible people 
(e.g. Children); the same applies to the unpacking tools (scissors, hammers, pliers, knives, etc.).

On specific request, the Manufacturer will pack the machines appropriately but this does not 
eliminate the above safety notes.

During movement, suspended loads made up of machine components or parts represent a 
collision, risk, it is the responsibility of the customer to highlight this danger.

Detergent tank

: The detergent tank is positioned underneath the recover tank with the water 

filling cap M1 (page 8) easily accessible for easy refilling.   Before filling the tank with correctly 
diluted detergent, empty the waste collection tank as described in the following paragraph; 
obviously this step is not required for the first time of filling. The capacity of the detergent tank is 
21 gallons. Only use the quantities and dilution recommended by the detergent supplier and use 
only non foaming detergents.

Waste tank:

 The waste tank should be emptied (preferably after each use) so as not to let the dirt

settle; to do this, remove the cap covering the drain tube M2 (page 7) which is held in place by 
a retaining spring, and put in a position so that it drains.  Or empty the tank and clean it with the 
help of the cap M0 (page 8).  Always abide by the environmental regulations of the country where 
the machine is used.  

Squeegee Assembly:

 The squeegee assembly serves to finish the drying operation and it is very 

important to ensure it is in the correct position: lower the squeegee to its working position by 
using the pedal to releasing the lever M3 (page 8).

Do not leave any metallic  tools or objects of any kind on the machine (see also IMPORTANT 
SAFETY INSTRUCTIONS) (page 3).

The area to be cleaned: 

The area to be cleaned should first be swept (manually or by machine) to 

remove loose dirt which may quickly clog up the vacuum system.

Batteries disposal.

Open the recovery tank disconnect the plug of the battery themselves.  Remove the screws that 
hold the cable to the batteries and remove them one at a time.  For the disposal of the batteries 
refer to a  disposal center; also see the notes about the disposal at the end of this manual.

It’s very important to avoid the maximum complete discharge of the batteries in order to have a 
longer battery life.  Avoid charging the batteries after a short time of use.

The operator must not wear clothing with wide sleeves, laces or belts; they must not approach 
the machine with bare or wet feet; they must not pull out the plug by pulling the cable; must not 
smoke if the environment or products used do not allow it.

NOTE: WHEN THE MACHINE IS NOT USED, IT MUST BE TAKEN IN A DRY ENVIRONMENT

CAUTION: 

 This machine is designed to work in closed industrial environments on level floors 

or on inclines no steeper than 2%. Do not use flammable chemicals and/or explosives with this 
machine.  Do not use or pick up flammable chemicals or liquids with this machine.

Summary of Contents for PFS32













Reviews: