Chapter 5 Function parameter
72
Ch
ap
ter 5
100%
A1
Corresponding setup
Frequency torque
10V(20mA)
0V(0mA)
100%
A1
Corresponding setup
Frequency, torque
10V(20mA)
0V(0mA)
-100%
100%
AI3
Corresponding setup
Frequency, torque
+10V
0V
-100%
-10V
Diagram 5-7:Relationship between analog reference and set amount
F1.16 Minimum input for AIC2
0.00V~F1.18
0.00V
☆
F1.17 F1.16 Corresponding to the set -100.00%~100.0%
0.0%
☆
F1.18 AIC2 max. input
F1.16~+10.00V
10.00V
☆
F1.19 F1.18 Corresponding to the set -100.00%~100.0%
100.0%
☆
For the function and use of curve 2, please refer to the description of curve 1.
F1.20 Minimum input for AIC3
0.00V~F1.22
0.00V
☆
F1.21 F1.20 Corresponding to the set -100.00%~100.0%
0.0%
☆
F1.22 AIC3 Maximum input
F1.20~+10.00V
10.00V
☆
F1.23 F1.22 Corresponding to the set -100.00%~100.0%
100.0%
☆
For the function and use of curve 3, please refer to the description of curve 1.
F1.24
AI
curve
selectio
n
Units digit
AI1 curve selection
321
☆
Curve 1(2 points
，
refere to F1.12~F1.15)
1
Curve 2(2 points
，
refere to F1.16~F1.19)
2
Curve 3(2 points
，
refere to F1.20~F1.23)
3
Tens digit AI2 curve selection (1-3, the same as the units digit)
Hundreds
digit
Panel encoder curve selection (1-3, the same as the
units digit)
Units digit, tens digit and hundreds digit of the function code are used to respectively select
the corresponding set curves of analog input AI1, AI2, Panel potentiometer
3 analog input can respectively select any one of 3 curves.
Curve 1, curve 2 and curve 3 are 2-point curve, they are set in F1 function code.
F1.25
AIinput
setting
selection
Units
digit
AI1 Below the minimum input setting selection
000
☆
Corresponding to the minimum input set
0
