10
11
7.
Insert the washers and nuts for the definitive mounting of the cubicle.
8. Insert the beam / boom into the housing of the fixing set, aligning the
mounting holes.
9. Once in position, tighten the nut and the bolt.
10. Power / energize the barrier according to the voltage of the purchased
product (127V or 220V).
Note:
Use 2.50mm² cables. Use a dedicated circuit breaker, i.e., a circuit
breaker to which only the barrier will be connected.
11.
Check / define the alignment of the bean (opening and closing).Use
mechanical stoppers for this purpose, moving them as needed.
12. The automatic barrier will be in good closing condition, when the
beam / boom is in the condition shown in the image below.
WASHERS AND
NUTS
STOPPERS FOR OPENING/
CLOSING ADJUSTMENT
BEAM / BOOM
BOLT
ASSEMBLY
HOLES
MOUNTED BEAM
/ BOOM
TIGHTENING NUT
AND BOLT
NUT
