14
OBS:
On the first activation, the barrier will move slowly in the opening
and closing directions as it reads the path. Soon after the reading, the
operation is normalized and will start operating at the factory default
speed. For more accurate adjustments, refer to the electronic board
options.
OPERATION
The barrier is operated by a micro-controlled control board, activated via
remote control or any other device that provides a NO (Normally Open)
contact.
TRIFLEX CONENCT AC CONTROL BOARD
The control board operates with a frequency inverter, which drives the
three-phase induction motor from a single-phase AC power supply and a
logic controller to carry out the inverter operations. For more information,
refer to the TRIFLEX CONNECT AC control unit manual.
ENCODER SYSTEM (DIGITAL REED)
An encoder monitors the barrier position. Also called Digital Signal
Angular Positioning Transducer System, it is used to precisely control and
monitor the gearmotor movements.
Therefore, there is the possibility of recording certain gate positions in
the memory and enabling the control board to control opening and
closing. This is done by employing sensors that inform the barrier travel
direction and position during operation.
Thus, it is a device responsible for the barrier path's reading, memorization,
and accuracy.
