Property of
www.ppgplans.com
– Do not duplicate or make public.
Last Revised Version: January 2010
© PPGPlans.com
Note:
For Fly Products harnesses, a J bar with different dimensions is needed. A drawing for this J
bar will be available in the future. Also needed are the plastic J bar ends available from
www.aerolight.com
for the webbing to slide through.
Slide the long straight part of the J bars into the protruding ends of the diagonal braces all the
way to the bolt. This can be a challenge as the J bar can be a tight fit in the square tube. File or
grind a nice bevel on the end of the J bar, use a Scotch Brite pad or steel wool to remove the
coating on the chromoly, use some grease and just twist and turn until the J bar bottoms out on
the bolt. It can be done! Drill a ¼ inch hole through the diagonal brace and J bar and install a
double button clip or AN4-14A bolt. (Picture 16)
