9
RETRANSMISSION PARAMETERS
The parameters required for configuring
Retransmission
are grouped on
PAGE-11.
The configuration includes selecting the
Output type, Recorder Low & High settings etc. Refer Table 5.1 for parameter description & settings.
Table 5.1
RECORDER HIGH
Set the Higher
PV
Limit that shall correspond to the maximum
recorder output signal level (20 mA / 10 V / 5 V).
(Default : -200.0)
Min. to Max. Range
Specified for the
Selected Input Type
Set the Lower
PV
Limit that shall correspond to the minimum
recorder output signal level (0 mA / 4 mA / 0 V).
RECORDER LOW
(Default : 0 to 20 mA)
0 to 20 mA
4 to 20 mA
0 to 5 Volts
0 to 10 Volts
RECORDER OUTPUT TYPE
Select type in accordance with the hardware module fitted. Select
0-20 or 4-20 mA, if Current output module is fitted. Select 0-5 or 0-
10 V, if Voltage output module is fitted.
Settings
(Default Value)
Parameter Description
Min. to Max. Range
Specified for the
Selected Input Type
(Default : 1376.0)
User Manual
neuro 100EX
Section 5