PQS 80000, Product Manual

PRODUCT MANUAL FOR WALL MOUNT SERIES ASSEMBLIES  

Page 4 of 15               

info@practicalqualitysystems.com

WW.PRACTICALQUALITYSYSTEMS.COM           (818) 993-1022

          Document Number:10010901-UM

1.1 Identifying, configuring and locating the mount for your application 

PLEASE NOTE:

 these instructions are for multiple 

Wall Mount

 product assemblies, refer to the “

List of 

Figures

” page to locate an exploded view of the assembly that you are using. 

All of these assemblies either include the 

P1

 mounting plate which supports one arm, or the 

P3

 mounting plate 

which can support either one or two separate arms (See Figures 1, 2 and 3). 

Both mounting plates can be installed Vertically or Horizontally on a WALL, or can be reconfigured for FLAT 
mounting positions. They can also be attached to a pole. 

Start by determining the desired configuration. If you are using the standard configuration with the 

P1

 or 

P3

mounting plate installed Vertically or Horizontally on a WALL, refer to sections 1.3 and 1.4.  

If you are reconfiguring your mount for FLAT mounting, please refer to sections 3.1, 3.2.    

1.2 Basic installation steps 

1.  Preassemble the mount for the desired configuration with the tilt head attached but without the 

equipment installed (See Figure 6). 

2.  Hold the assembly with the mounting plate against the mounting surface to determine its best location.   

3.  Pivot the arm so that they can be rotated through their entire range of motion and does not conflict with 

the surrounding surfaces. Be sure to take into consideration the additional space that the equipment will 
need once it is attached to the end of the arm. 

4.  Once the mounting location has been determined, mark the locations for the fasteners through the 

holes on the sides of the mounting plate. Follow the installation instructions that are appropriate for your 
application. 

2.1 Installing the mounting plate on a WALL either horizontally or vertically 

1.  The mounting plate feature either one or three patterns of ¼”-20 threaded holes for the insertion of the 

four mounting screws that attach the 

SB

 (stand off) brackets and arms to the mounting plate. The 

mounting screw pattern allows the 

SB

 brackets and arms to be removed and remounted to the plate if it 

is installed either vertically or horizontally. In this configuration, the 

SB

 brackets provide the first pivot 

point for the arms, allowing them a full range of side to side motion (See Figure 7). 

2.  Remove the pan and tilt heads and/or the 

Universal Printer Mounting Tray

 from the arm(s). 

3.  Remove the arm(s) with the 

SB

 bracket(s) from the mounting plate. 

4.  Securely attach the mounting plate to the mounting surface with four or more fasteners that are 

appropriate for the mounting surface material.