PQS 80000, Product Manual

PRODUCT MANUAL FOR WALL MOUNT SERIES ASSEMBLIES  

Page 5 of 15               

info@practicalqualitysystems.com

WW.PRACTICALQUALITYSYSTEMS.COM           (818) 993-1022

          Document Number:10010901-UM

 
2.2 Reattaching the arms to the mounting plate installed on a WALL either horizontally or 
vertically 

1. The 

SB

 brackets should still be attached to the ends of the arms. Hold the arm so that the five point 

knob is on top of the 

SB

 bracket. Align the holes in the 

SB

 bracket with one of the patterns of threaded 

holes on the mounting plate (See Figure 7). 

2.  Loosely install the four ¼”-20 Philips 

SB

 securing screws through the 

SB

 bracket and into the threaded 

holes in the 

P3

 mounting plate. Do not fully tighten the screws until all of the screws are threaded into 

the plate.  

3.1 Installing the mounting plate FLAT on top of a horizontal surface 

The mounting plates also have one or three larger 5/16”-18 threaded holes in the centers of the 

patterns of ¼”-20 threaded holes, which are used to attach the arms when the plate is installed in a flat 
configuration. In this configuration, the larger center hole provides the first pivot point for the arms, allowing 
them a full range of side to side motion. 

1.  If you are mounting the plate flat on top of a horizontal surface, the 

SB

 bracket and the four ¼”-20 

Philips securing screws are not used. To remove the arm from the 

SB

 bracket, unscrew and 

remove the five point knob from the top of the 

SB

 bracket and slide the arm out.   

2.  Remove the pan and tilt from the arm(s). 

3.  Remove the arm(s) with the 

SB

 bracket(s) from the mounting plate. 

4.  Remove the arm(s) from the 

SB

 bracket(s). 

5.  Securely attach the mounting plate to the mounting surface with four or more fasteners that are 

appropriate for the mounting surface material.  

3.2 Reattaching the arms to the P1 or P3 mounting plate installed FLAT on top of a horizontal 
surface 

1.  Note that the arms have two washers welded to the top and bottom of the mounting plate end, and only 

one washer welded on the top of the tilt head end.  

2. Once the 

SB

 brackets have been removed from the arm(s), place one of the anti-slip washers on the 

pattern of threaded holes on the mounting plate, and align them with the large threaded holes located 
within the center of the patterns of threaded holes.   

3.  Holding the arm(s) so that the single washer end (Pan and Tilt Head End) is facing up, insert the five 

point knob with the threaded shaft pointing down into the top of the two washer ends (the mounting 
plate end) of the arm(s).  

4. Carefully

turn the knob to thread the knob shaft into the plate and tighten it only until some resistance is 

felt, and no space can be seen the between the mating surfaces of the anti-slip washer, the plate and 
the lower washer on the mounting plate ends of the arms.