PQS 80000, Product Manual

PRODUCT MANUAL FOR WALL MOUNT SERIES ASSEMBLIES  

Page 6 of 15               

info@practicalqualitysystems.com

WW.PRACTICALQUALITYSYSTEMS.COM           (818) 993-1022

          Document Number:10010901-UM

4.1 Basic steps for mounting a screen with VESA standard mounting holes 

1.  Remove the pan and tilt head from the end of the arm. 

2.  Remove the arm assembly from the mounting plate. 

3.  Install the mounting plate and reattach the arm(s).  

4.  Install the VESA pan and tilt head to the back of the screen. (Refer to Section 4.2 Below) 

5.  Install the pan and tilt head and the screen together as a unit onto the end of the arm. (Refer to Section 

4.4 Below) 

4.2 Attaching the VESA pan and tilt head to a VESA standard flat panel monitor, touch screen 
or terminal 

1.  Place the unit with the screen facing down on a smooth flat surface and remove the VESA mounting 

screws from the back of the monitor. If the screws are not present, refer to the unit manual or contact 
the manufacturer to obtain the correct type and length of screws. 

2.  Lay the VESA pan and tilt head flat on top of the back of the screen. Align the four holes in the VESA 

pan and tilt head with the pattern of four threaded holes on the back of the screen. 

3.  Loosely install the four screws through the VESA pan and tilt head and into the threaded holes on the 

back of the screen. Do not fully tighten the screws until all of the screws are threaded into the back of 
the screen. 

4.3 Basic steps for installing a Universal Printer Mounting Tray (UPMT) 

1. Remove 

the 

Universal Printer Mounting Tray

(UPMT)

from the end of the arm. 

2.  Remove the arm assembly from the mounting plate. 

3.  Install the mounting plate and reattach the arm. 

4. Install 

the 

UPMT

 on the end of the arm (See Figure 6). 

5.  Install the printer on the 

UPMT

. 

5.1 Attaching a pan and tilt head or Universal Printer Mounting Tray to the end of the arm 

1.  Lay the anti-slip washer on top of the end of the arm (See Figure 7). 

2.  Check that the bottom of the pan and tilt head is flat and that the four point tilt knobs are tightened 

enough so that the pan and tilt head cannot move easily. 

3.  Carefully lift the monitor or 

UPMT

 and center the bottom hole of the pan and tilt head or tray over the 

hole in the end of the arm. 

4.  Gently lower the monitor until the bottom of the pan and tilt head is resting slightly on the end of the 

arm. Do not release your grip on the monitor or 

UPMT

.