Ceiling Mount with a 7 Axis Extendable Arm and a 75-100mm VESA Screen Pan and Tilt Head
PN 80104-MICROS, PN 80104-20-MICROS, PN 80104-26-MICROS
3
info@practicalqualitysystems.com
WWW.PRACTICALQUALITYSYSTEMS.COM
(818) 993-1022
ALL PRODUCTS PATENT PENDING
Enhanced MICROS compatible Pan and Tilt Head with side-to-side tilt adjustment on an Offset Arm
Bracket
•
A universal mount that works with any MICROS compatible terminal with then tabs and slots standard.
•
Tightening the 2 four-point knobs applies variable clutching resistance to allow adjustment of the up
and down tilt position of the terminal. Tighten either of the two 10-32 Phillips head screws adjacent to
the four-point knobs to permanently secure the tilt position.
•
Tightening the five- point knob below the Offset bracket applies variable clutching resistance to allow
adjustment of the side-to-side pan position of the terminal. A 10-32 Phillips head screw in the center of
the lower Panning plate can be tightened to permanently secure the pan position.
•
Tightening the three - point knob at the rear center of the MICROS compatible mounting plate applies
variable resistance to allow adjustment of the side-to-side terminal tilt position.
•
Tighten the 10-32 Phillips head screw on the lower Panning plate into one of the holes in the Offset
bracket to permanently secure the pan position.
•
The Offset Bracket attaches the MICROS compatible pan and tilt head to the end of the arm and allows
adjustment of the up and down “Offset angle” of the arm.
•
Adjusting the Up and down position of the arm at the Offset bracket: Remove the 1/4” Wire-Lock Clevis
Pin from the Offset Bracket to adjust the up and down position of the arm; then reinsert the pin into one
of the holes in the Offset bracket and through the arm to secure the new position.
MICROS quick connect
tabs and slots adapter
plate is attached here
