HOW TO DISMANTLE SYSTEM 2200
The back panel of the module is detached from the housing by way of a
screwdriver as shown in picture 1 .
On a module with knobs, these may have to be removed before the PCB can be
taken out as shown in picture 2 .
After this, the back panel can be pulled out together with the PCB, but please
notice the position of the PCB as there is a number of different positions in the
house . Do not pull the wires unnecessarily, instead pull the PCB, see picture 3 .
Switches and jumpers can now be moved .
When assembling the back plate and housing, please make sure no wires are
stuck .
Picture 1: Dismantlement of back plate
and housing
Picture 2: Removal of knobs
Picture 3: Removal of PCBs for adjustment of DIP-switches
and replacement of jumpers .
DECLARATION OF CONFORMITY
As manufacturer
pR electronics A/S
hereby declares that the following product:
Type: 2240
Name: Transformer
is in conformity with the following directives and standards:
The EMC Directive 2004/108/EC and later amendments
EN 61326-1
For specification of the acceptable EMC performance level, refer to the
electrical specifications for the module .
The Low Voltage Directive 2006/95/EC and later amendments
EN 61010-1
The CE mark for compliance with the Low Voltage directive was affixed in the
year:
1997
Kim Rasmussen
Manufacturer’s signature
