9
Before the lamp’s removal, unplug its both wires. After a new lamp installed, plug its both wires.
●
Don’t touch the internal surface of the reflector and the burner of the lamp with bare hands so as not to
impair the beam output. While lamp’s installation, do not damage the metal wire around the burner.
●
Please read "Instructions " enclosed with the lamp
●
Do operate the projector while adjusting the lamp
●
REPLACEMENT OF GOBOS
Replacement of a rotating gobo wheel: open the cove and select a rotator to be replaced. Push the rotator towards the front lens till it
slides from the wheel and pull it out gently; After a replacement of a gobo, place the rotator in its original place and ensure it is in right
place and not loose.
DANGER!
Before replacement of gobos, the projector must be off the power.
5.
SETUP AND CONFIGURATION
●
FRONT PANEL OPERATION
1
2
Rotating gob wheel
Rotator
Rotator accessory
Gobo
Gobo spring
