UNIK2E230
V2
ENGLISH
ISUNIK2E230v2_GB_10_12.doc
7
4.3
PROFESSIONAL LEARNING PROCEDURE (see also pages 8-10)
Using the professional learning procedure the installer can determine:
a) the instant in which the opening and closing slow-down starts
b) the pedestrian function
c) the safety device trigger mode.
When the motor and safety devices are connected and the initial set-up has been completed, programme the
remote controls that will be used (see page 8) with the gate stopped (green LED GC turned on).
Yellow LED
flashes
Yellow LED
stays on
The control unit briefly opens
If motors turns in reverse, invert wires
and start procedure again from RESET.
Closes the second gate
and then the first.
RESET:
press and hold the
programming button
P1/SET for 2 seconds
Position the
gates half open
Within 5 seconds, press
the programming button
P2/RAD for 1 second
Stop then
invert
Stop then
invert when
cleared
Yellow LED turns off.
End of learning.
When the slow-down is to
start press button 1 of a
remote control for leaf 1
and button 2 for leaf 2.
Press P1/SET or
remote control
button 1.
The gate closes
Will pedestrian
function be used?
Press
together
P1/SET and
P2/RAD
Press the button of the remote
control that will be used for the
pedestrian function (different from 1)
Control unit starts pedestrian
opening
Press P1/SET or button 1 of
the remote control to stop
pedestrian opening
Press P1/SET or button 1 of the
remote control
NO
YES
only by
wire
Photocell “PHO”
in closing must:
Press P2/RAD or
button 2 of the
remote control
Opening slow-
down
Pedestrian function
Safety
intervention in
closing
Safety intervention
in opening
The “EDG” safety in
opening must:
Stop then
open when
cleared
Stop then
invert for 2
sec.
Press P1/SET or
remote control
button 1
Press P2/RAD or
button 2 of the
remote control
Limit switches or mechanical
stop intervention or press
button 1 of a remote control
for leaf 1 and button 2
for leaf 2.
YES
NO
End of opening
When the slow-down is to
start press button 1 of a
remote control for leaf 1 and
button 2 for leaf 2.
Closing slow-
down
Limit switches or mechanical
stop intervention or press
P1/SET for leaf 1 and P2/RAD
for leaf 2.
YES
NO
End of closing
Adjust trimmers if necessary.
ATTENTION
A variation of trimmer “FOR” (speed) requires the repetition
of the learning procedure from RESET
.
MANUAL INTERVENTION TO CHANGE THE FUNCTIONS
YES
by radio
+ by wire
The gate opens
Control unit carries out
STOP and re-closing
Limit switches or mechanical
stop intervention or press
P1/SET for leaf 1 and P2/RAD
for leaf 2.
Limit switches or mechanical
stop intervention or press
button 1 of a remote control
for leaf 1 and button 2
for leaf 2.
Intelligent Security & Fire Ltd.
