PRAXAIR
®
StarWatch™ Connect Website
P-15-754
User Guide
Issued: 11 Jul 2016, Revised: 12 Oct 2016
StarWatch Connect Regulatory Statements
The following regulatory statements apply to the StarWatch Connect system, consisting of a (1) StarWatch Connect wireless transmitter (FCC
ID: SZ9ZPOINT; IC: 10940A-ZPOINT), (2) StarWatch Connect CDMA cellular gateway (FCC ID: RI7CE910-DUAL), and (3) StarWatch
Connect GSM cellular gateway (FCC ID: RI7HE910, S4GEM35XB; IC: 10940A-GWGSM). All statements below apply to all devices, unless
otherwise specified.
Federal Communications Commission (FCC) Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment.
Industry Canada (IC) Statement:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
StarWatch Connect wireless transmitter
This device has been designed to operate with the antennas listed below, and having a maximum gain of 2.5dBi. Antennas not included in this list
or having a gain greater than 2.5dBi are strictly prohibited for use with this device. The required antenna impedance is 50
Ω.
•
External 2.4GHz dipole, male RP-SMA antenna with maximum gain of 2.3dBi.
•
External 900/1800/1900MHz omni CDMA male SMA antenna with maximum gain of 2.5dBi.
StarWatch Connect GSM cellular gateway
This device has been designed to operate with the antennas listed below, and having a maximum gain of 3.0dBi. Antennas not included in this list
or having a gain greater than 3.0
dBi are strictly prohibited for use with this device. The required antenna impedance is 50Ω.
•
External 2.4GHz dipole, male RP-SMA antenna with maximum gain of 2.3dBi.
•
External 850/900/1800/1900MHz quad band omni GSM male SMA antenna with maximum gain of 3.0dBi.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that permitted for successful communication
WARNING!
FCC and IC Radiation Exposure Statement:
This equipment complies with FCC’s and IC’s RF radiation exposure limits set forth for an uncontrolled environment under the following
conditions:
1.
This equipment should be installed and operated such that a minimum separation distance of 20cm is maintained between the radiator
(antenna) & user’s/nearby person’s body at all times.
2.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
