25
M4X6
FIGURE 4.2
FIGURE 4.3
STEP 4.1 |
INSTALLING MOTHERBOARD
FLAT VARIATION
STEP 5 |
INSTALLING RADIATOR TRAY
FLAT VARIATION
Screw in
2 M4x6 lowhead screws (part 2)
to the front of
each leg. Don’t completely tighten these (figure 4.3) as the
motherboard tray will slide under the screws as shown in figure
4.2. After installing the motherbord, you can either tighten the
screws down or keep them loose for easy disconnect.
M4X6
FIGURE 5.1
Spin your wetbench to the back and place
2 M4x6 lowhead
screws (part 2)
on each leg. As with previous step, keep these
loose so your radiator mount can be slid on and off (figure 5.1).
Once everything is installed you can tighten down the radiator
bracket or keep it as is for easy disconnect.
RADIATOR TRAY CAN
BE INSTALLED ON
FRONT OR BACK
