Page
15
of
30
Operating the stapler
Regulating the stapler with the operating pressure
You can set the penetration depth of the stapler into the material by regulating the operating
pressure. At a higher operating pressure, the nails are driven deeper into the material; setting a
lower operating pressure reduces the penetration depth.
Set the operating pressure to achieve the required penetration depth. This has the
following benefits:
•
you save energy (compressed air),
•
you reduce the noise level, and
•
you reduce the wear of the stapler.
Proceed as follows to set the operating pressure:
➢
Adjust the pressure at the pressure valve of the compressor or compressed air system.
➢
Observe the pressure reading.
Checking the penetration depth
➢
Shoot a staple into a sample workpiece with the same characteristics as the processing
material.
➢
Repeat these steps until you have set the required penetration depth.
Summary of Contents for 11-WP130
