Page
16
of
30
Servicing the stapler
The stapler may only be serviced by persons who have the necessary knowledge, skills and
experience. Any work not described here may only be performed by the manufacturer's customer
service team or by the manufacturer.
During all servicing work, the compressed air connection and the control line between
the stapler and the production system must be disconnected.
WARNING
Unintentionally activating the stapler when emptying the magazine can
result in serious or fatal injury.
➢
Disconnect the stapler from the compressed air supply before
cleaning it.
➢
Remove the magazine and all staples from the feed channel and
on feed bridge.
Cleaning the housing and outer surface
Important
The stapler or accessories can be damaged by using unsuitable cleaning agents.
➢
Only use a dry, slightly moistened cloth or a cloth moistened with mild soapy water for
cleaning the stapler.
Light soiling
➢
Wipe the stapler housing clean with a dry cloth.
Severe soiling
➢
Wipe the stapler housing clean with a cloth lightly moistened with mild soapy water.
➢
Then wipe the housing with a cloth slightly moistened with tap water.
➢
Rub down with a dry, soft cloth.
Soiling in the discharge channel/feed bridge
The discharge channel and feed bridge should be cleaned at regular intervals depending
on the discharge intensity.
Use of the staples can cause adhesive residue to accumulate in the discharge channel and on the
feed bridge.
➢
Remove this residue using a compressed air gun and a fine cleaning brush.
Summary of Contents for 11-WP130
