PREBENA
Wilfried Bornemann GmbH & Co. KG
BEFESTIGUNGSTECHNIK
– FASTENING TECHNOLOGY
23
To install a new filter / oil separator, having previously greased the gasket of the
filter with oil. To do so, use the same oil as for filling the compressor.
9 To close the drain valve and fill the new oil through the filler neck to the upper
edge of the inspection hole of the oil indicator. Then screw the plug back into the
filler neck.
10 To switch on the compressor and then switch it off again after reaching the oil
temperature of more than 71°
С. After the oil-foam subsides, you can then check
the oil level through the inspection window and top up if necessary.
11 To replace the right panel of the compressor housing.
NOTE: IN THE CASE OF AN ELEVATED DUST CONTENT IN THE AIR, MORE
FREQUENT MAINTENANCE MUST BE PERFORMED. SPECIAL
CONSIDERATION MUST BE GIVEN TO HE RADIATOR IN THIS REGARD. IT
MUST BE CLEANED/REPLACED MORE OFTEN, ALONG WITH THE AIR FILTER.
8.3.4
Cap for draining oil
The cap for draining the oil is located at the bottom of the oil sump and serves the
purpose of draining the oil during maintenance and oil change.
When draining the oil, the condensate must also be removed via the cap (if required).
All tasks / activities in which the cap has to be removed should be performed when
there is no pressure in the oil sump and when the compressor is off.
8.3.5
Oil filler neck
The oil filler neck is located directly on the oil tank and is locked with a special screw
(Figure 5)
. This lock can only be opened when the pressure in the compressor
corresponds to the normal air pressure. Danger: The cap should not be removed
when the compressor is running or is pressurised.
Figure 6
Figure 5
Summary of Contents for SK-15-10
