Helios PD2-6080/PD2-6081 Modbus
®
Scanners
Instruction Manual
14
Wall Mounting Instructions
The scanner can be mounted to any wall using the
four provided mounting holes. Note that the bottom
mounting holes are located underneath the lower door
panel. To mount the scanner to a wall, follow these
instructions
•
Prepare a section of wall approximately 11" x 13"
(280 mm x 330 mm) for scanner mounting by
marking with a pencil the mounting holes (shown
in
) on the wall.
•
Select the appropriate mounting screws for the
mounting surface to be used. The mounting holes
diameter is shown on
Note: Mounting screws are not included.
•
Using a drill bit slightly smaller than the girth of
the mounting screws, pre-drill holes at the
mounting locations previously marked.
•
Insert mounting screws into the four mounting
holes and screw them into the pre-drilled holes.
DO NOT
overtighten the mounting screws as it is
possible that the enclosure could crack and
become damaged.
Figure 1. Scanner Mounting Holes Location
Figure 2. Scanner Mounting Holes Dimensions
Mounting Dimensions
Figure 3. Scanner Dimensions
– Side View
Figure 4. Scanner Dimensions - Front View
Conduit Holes Location
Figure 5. Conduit Holes Location
– Bottom View
Mounting Hole
Mounting Hole
Mounting Hole
Mounting Hole
Lower
Door
Panel
10.43" (265 mm)
9
.8
" (
2
4
9
m
m
)
11.14" (283 mm)
Dia. 0.2"
(5.5 mm)
Dia. 0.2"
(5.5 mm)
2.63" (67 mm)
4.77"
(121.2 mm)
1
0
.6
3
"
(2
7
0
m
m
)
12.59" (319.7 mm)
Mounting Hole
Mounting Hole
Lower
Door
Panel
Plugged
Holes
Unplugged
Holes
1.1"
(27.9 mm)
1.99"
(50.5 mm)
0.9"
(23 mm)
Ø0.74" (18.9 mm)
Drill or Punch-Out Holes
