PD865 Snooper Modbus
Serial Input Meter
Instruction Manual
63
TROUBLESHOOTING
If the meter is not working as expected, refer to the troubleshooting tips
on page 68.
Determining Software Version
To determine the software version of the meter:
1. Go to the Information menu (
info
) in the Advanced Features
menu and press the Enter/Ack button.
2. Press
Enter/Ack to access the software number (
SFT
), version
(
UER
), and serial number (
Sn
) information. Write down the
information as it is displayed. Continue pressing Enter/Ack until
all the information is displayed.
Reset Meter to Factory Defaults
When the parameters have been changed in a way that is difficult to
determine what is happening, it might be better to start the setup
process from the factory defaults.
Instructions to load factory defaults:
1. Enter
the
Advanced features menu. See Advanced Features Menu,
page 52.
2. Press
Up arrow several times to go to the Information menu.
3. Press and hold Right arrow/Reset for five seconds, then press
Enter/Ack when display flashes
reset
.
Note: If Enter/Ack is not pressed within three seconds, display
returns to meter Run.
4. The meter loads the factory default settings, and goes through an
initialization sequence (same as on power-up).
info
Press and hold
for 3 seconds
reset
Press and hold
for 5 seconds
Flashing
Display
Meter
Reinitializes
