6
OPERATING INSTRUCTIONS
CAUTION
Inspect the Easy Comp Compressor for visual damage,
DO NOT USE if damaged.
1. Become familiar with the Compressor (see Component
Identification).
2. Place Compressor near a properly grounded electrical
receptacle on a table, floor or other horizontal, smooth,
hard surface. Allow a minimum of 4 in. (10 cm) clearance
on all sides to ensure adequate air flow for cooling of
product.
3. Press down on Compressor until Suction Feet are secure.
4. Ensure the On/Off Switch is in the “OFF” position.
5. Plug the Compressor into a receptacle.
6. Attach appropriate device to the Outlet Fitting, securely,
without overtightening.
7. Press the On/Off Switch to the “ON” position.
8. Adjust pressure.
To INCREASE pressure - Turn Knob CLOCKWISE
To DECREASE pressure - Turn Knob COUNTERCLOCKWISE
9. Begin procedure.
10. When procedure is complete, press the On/Off Switch to
the “OFF” position.
Summary of Contents for EasyComp PM50-3HG
Page 1: ...Model PM50 3HG shown...
