5
4. Install the computer
Pull the wire of computer (8) through the computer bracket (30) and
out from the hole. Then attach the computer (8) into the computer
bracket (30). Connect the computer wire with the extension wires (18).
Finally, attach the computer bracket (30) onto the top of handlebar
post (4).
5. Install the Saddle Post
Fix the saddle (7) to the saddle post (6) with flat washers
(21) and nylon nuts (22), and then insert the bushing to
the saddle post (6).Finally, insert the saddle post(6) into
the main frame (1), tighten with the knob (31).
Note
:
when adjusting the height of saddle post, the
maximum insert depth mark line cannot be higher than the
edge of the tube of Main Frame section.
6. Install the Right and Left Pedals
Attach the right and left pedals (9L/R) to the crank (10)
respectively. The right pedal (9R) should be threaded
clockwise. The left pedal (9L) should be threaded
counterclockwise.
Note:
The right and left Pedals (9L/R) are marked “
R
” for
right & “
L
” for left.
Summary of Contents for PRE105
Page 3: ...2 EXPLOSIVED DIAGRAM...
