3.2 Checking package contents
3 - 24
© Precitec GmbH & Co. KG • EN 09/2019
3.2
Checking package contents
The following checks should be carried out before fitting the laser head:
• Are the parts supplied complete?
• Is there any visible damage?
Package contents
Basically, you will need the following parts:
• Laser head
(LightCutter)
with integrated beam shaping optics
(collimating and
focusing lenses, protective window)
and sensor insert
(SE)
pre-assembled
(version as stated on the delivery note)
• Ceramic part
(KT)
and nozzle electrode
(DE)
• Sensor cable
• Analysing electronics
(version as stated on the delivery note)
Caution – Overpressure!
An overpressure of up to 25 bar
(2.5 MPa)
can be supplied to the laser head
through the relevant connection point. The laser head's functional efficiency
must always be guaranteed to avoid any accidents. If damaged, the laser head
must be protected against accidental use. Damaged parts must be replaced.
