3.3 Fitting
3 - 28
© Precitec GmbH & Co. KG • EN 09/2019
3.3.4
Fitting the cutting head to the machine
(trained personnel only)
Fig. 3-4
Fitting: Laser head to the machine
Laser head
(back)
The laser head is fixed using the four threaded holes M6x1
(14.5 mm deep)
at
the back.
Two pin holes ø4
F7
(8 mm deep)
aligned in a diagonal pattern are used to
position the unit precisely and in such a way that this position can be
reproduced.
Attention – Risk of vibration!
When fitting the laser head to the machine, the machine manufacturer must
take appropriate measures to prevent the laser head from vibrating.
54412-
LC
an
-0
8
L*
(l
ength)
Cutting head
L*
[mm]
LightCutter F100/ F125
97.1
LightCutter F150
134.4
LightCutter F200
171.7
