5.5 Care and maintenance of the protective window cartridge
5 - 44
© Precitec GmbH & Co. KG • EN 09/2019
5.5
Care and maintenance of the protective window cartridge
The components installed in the laser head's beam path must be handled with
care.
Fig. 5-3
Maintenance: Protective window cartridge
Removing and installing the cartridge
Attention – Clean workplace!
Only carry out any maintenance and replacement work on the laser head in a
clean workplace.
LC-
BA-oO
gk
You
should
have a replacement cartridge ready at hand before you start
removing the protective window cartridge.
If no second protective window cartridge is available, we recommend that you
order one from Precitec
(see Appendix)
or immediately affix a suitable protective
film over the aperture to cover it
(see MOCAP's product range for instance).
Unlock and remove the cartridge and put it on a clean pad
(horizontal position)
.
Attention:
Cover the opening on the laser head with protective film immediately.
Note:
The protective window must be replaced in a clean workplace (see
Remove any protective foil from the laser head, hold the cartridge
(with protective
window fitted)
in a horizontal position, insert it into the laser head and screw it on
again.
Note the orientation of the protective window cartridge when doing this. A wrongly inser-
ted cartridge will not click into place.
