6 Specific characteristics of the 3D version
© Precitec GmbH & Co. KG • EN 09/2019
6 - 57
6.2.3
Fixing the cutting head to the machine
(trained personnel only)
6.2.3.1
Laser head - hole pattern
Fig. 6-6
Installation: Laser head to machine
(3D version)
Laser head
(back)
The laser head is fixed using the four threaded holes M6x1
(14.5 mm deep)
located at the back.
Two pin holes ø4
F7
(8 mm deep)
aligned in a diagonal pattern are used to
position the unit precisely and in such a way that this position can be
reproduced.
Attention – Risk of vibration!
When fitting the laser head to the machine, the machine manufacturer must
take appropriate measures to prevent the laser head from vibrating.
LightCx3D_o9
