5.17 Ellipitical Fitness Crosstrainer
Page 28
Procedure 6.1 - Replacing the Front or Rear Covers
Procedure
1.
Set the on/off switch in the “off” position, then unplug the power adapter from the EFX.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
Removing and Replacing the Rear Cover
2.
Remove the 7 screws that secure the rear cover halves. Remove the 6 screws that secure
the rear covers to the frame.
3.
Remove both of the rear cover halves.
4.
When maintenance operations are complete, position the rear covers at their mounting
positions. Replace the 6 screws that secure the rear cover to the frame. Replace the 7
screws that secure the rear cover halves.
Removing and Replacing the Front Cover
5.
Remove the 6 screws that secure the front cover halves. Remove the front half of the front
cover.
6.
If the cover was removed to access the lift motor, it is not necessary to remove the rear half
of the front cover. If the rear half of the front cover must be replaced, continue with step 7.
Otherwise, skip to step 16.
7.
Remove the retaining clip from each lift nut mounting pin. Support the lift ramp assembly
and remove the lift nut mounting pins from the lift nut. Raise the ramp and support it from the
handlebars using a bungi cord (See Diagrams 6.1 and 6.2).
