9.23, 9.27 Treadmill
Page 7
Procedure 2.3 - Accessing the Upper PCA to Lower PCA
Initialization Program
Warning
During this procedure the running belt will be accelerated to the treadmill’s maximum
(12.0 mph) speed.
Do not
stand on the treadmill’s running belt during this procedure.
1.
This procedure
must
be performed after the upper PCA, the upper PCA software or the
lower PCA has been replaced and before the treadmill is placed into normal operation.
2.
If the on/off switch is in the “on” position, set the on/off switch in the “off” position for a
minimum of 10 seconds to allow the internal power supply to discharge
3.
Remove the safety key from the console and set the on/off switch in the “on” position.
4.
While pressing the
INCLINE
S
and
SPEED
T
keys, replace the safety switch on the
console. Continue to press the
INCLINE
S
and
SPEED
T
keys until the display goes blank.
The word
init
will appear in the display’s time window. The EEPROM has now been cleared
and reset. After 1-1/4 seconds, 1.25 will be displayed in the display’s distance/calories
window, the maximum incline (15.0) will be displayed in the display’s incline window and
maximum speed (12.0) will flash in the display’s speed/pace window.
5.
Press the
QUICKSTART
key to start the speed calibration process. Power bits will be
displayed in the display’s incline window, the target speed will be displayed in the display’s
time window and the actual speed will be displayed in the display’s speed/pace window.
Initially the target speed will be 0.5. The running belt will then start. When the actual speed
reaches 0.5, the target speed will change to 12.0 and the running belt will continue to
accelerate until it reaches 12.0 mph and then stop.
6.
When the running belt stops the display will return to the normal user mode and the
initialization process is complete.
