C546 Elliptical Fitness Crosstrainerl
Page 97
Procedure 7.25 - Replacing All or Part of a Ramp Assembly
Procedure
1.
Set the on/off switch in the “off” position, then unplug the power cord from the wall outlet.
2.
Remove the rear cover per Procedure 7.1 and pivot both stairarms to the rear of the unit.
3.
Remove the four screws that fasten the ramp end cap to the ramp assembly. Slide the ramp
end cap out of the ramp assembly and rotate the ramp assembly toward the rear of the unit.
4.
If the ramp end cap is not being replaced, do not allow the ramp end cap to rotate on the lift
motor drive screw. If the ramp end cap is rotated, the lift motor must be re-calibrated per
Procedure 5.2.
5.
If only the ramp end cap is being replaced skip to step 13. Otherwise continue with the next
step.
6.
Remove the ramp pivot block mounting screws from one of the ramp pivot blocks. Slide the
entire ramp off of the frame pin and place it in a convenient work area. Slide the other ramp
pivot block off of it’s frame pin. (See Diagram 7.20)
Diagram 7.20 - Ramp Pivot
Ramp
Assembly
Pivot Block
Screw
Frame Pin
Pivot Block
Summary of Contents for C546
