Pulldown Assembly Guide: Assembling the Equipment
11
Installing the Movement Arms
You will need an assistant to hold the movement arms in place while you
complete this procedure.
To install the movement arms:
1.
Position the axle end of one movement arm within its pivot bracket on the
frame so that the openings in the bracket and the movement arm are
aligned.
2.
Press an axle through the openings in the bracket and the movement arm.
Note:
The axle should slide easily through the openings. You should not
need to do anything more than tapping it lightly with a rubber mallet to
move it into place. If the axle becomes jammed during this step, check to
make sure the movement arm and the bracket are still aligned. If the axle
remains jammed, remove it and contact Customer Support.
3.
Place an axle mount end on each end of the axle and attach a M12 x 30
mm flat head screw to each end, as shown in the following figure.
Figure 7: Movement arm axle installation
4.
Check that the axle is properly positioned and centered, then tighten the
screws completely.
Important:
The screws should be tight enough to prevent the movement arm
from rocking from side to side when in use.
5.
Repeat steps 1 through 4 to install the other movement arm.
Important:
Test the operation of the movement arms after you have installed them.
Make sure they move smoothly through their entire range, without binding or
shifting.
Summary of Contents for Discovery Plate Loaded Pulldown Series
